a) Remove rubber fill plug from the top of the tank.
b) Place a large bucket of water next to the rower. Position the Siphon
25
with rigid
hose in the bucket, and flexible hose in the tank. Make sure small breather valve on
siphon is closed before filling. Filling will take approximately 7.6 liters of water.
c) Squeeze siphon to begin filling.
d) When full, open the valve on the top of the siphon to allow excess water to escape.
e) Once filling is complete follow the water treatment schedule below, then replace the
tank plug.
STEP 9
TREAT THE WATER AND FILL THE TANK
REQUIRED
Siphon
25
RESISTANCE ADJUSTER
MUST BE SET TO 16 TO
ALLOW FOR ACCURATE
FILLING CAPACITY.
DO NOT OVERFILL THE
TANK BEYOND MAXIMUM
LEVEL INDICATED, REFER
TO THE TANK LEVEL DECAL
ON THE LOWER SIDE OF
THE TANK.
IMPELLER BLADES
ARE SHARP! DO NOT
PLACE FINGERS IN
TANK TO ADJUST
IMPELLER POSITION.
CAUTION
WARNING
WARNING
NOTE:
THE SIPHON TUBE MAY BE IMPEDED BY ONE OF THE IMPELLER BLADES. USE THE SIPHON
ONLY TO PUSH THE IMPELLER DOWN SLIGHTLY.
Siphon Valve
INITIAL WATER TREATMENT
Add 1 x Water Treatment Tablet per full tank. DO NOT, UNDER ANY CIRCUMSTANCE, USE
A WATER TREATMENT TABLET OTHER THAN THOSE SUPPLIED WITH YOUR UNIT.
Your unit purchase includes 4 x Water Treatment Tablets, which is sufficient for several
years of use.
ASSEMBLY
18
