23
CLEANING AND MAINTENANCE
DAILY
1. Cleaning the HydroSeeder
®
A. Fill slurry tank to center of agitator shaft with clear water.
B. Move agitator lever to full speed (forward or reverse) to flush off inside of tank top
and walls.
C. Remove discharge nozzle and coupler gasket from remote valve coupler at the end
of the discharge hose.
D. While aiming the discharge hose toward an open area, open DISCHARGE and
remote valves and engage (turn on) the pump clutch. Allow to discharge until clear
water is coming out.
E. Open RECIRCULATION valve and allow to run until stream is clear.
F. Disengage (turn off) the pump clutch, idle the engine, move DISCHARGE valve
handle to OPEN position, move agitator handle to NEUTRAL, and turn off the
engine. (Remember to replace coupler gasket.)
G. Always remove drain plug and allow tank to drain.
H. In freezing weather, leave main tank drain plug out and remove pump drain plug.
Move all slurry valves to OPEN position.
I. Wash the outside of HydroSeeder® to remove any corrosive materials.
J. Replace coupler gasket before re-installing discharge nozzle onto remote valve
coupler.
2. Lubricating the HydroSeeder
®
(See LUBRICATION AND FLUIDS CHART.)
Lubrication should be performed IMMEDIATELY AFTER cleaning of
the equipment, with the engine not running.
A. Lubricate agitator shaft bearings located on the outside-front and rear of slurry
tank.
B. Service automatic pressure lubricator on pump as needed.
C. Check engine oil and replenish when necessary. Change oil and filter after first
5 hours, then every 100 hours thereafter. Consult the engine operator’s manual for
correct grade of oil and the engine break-in procedure.
D. Check the hydraulic oil level in the hydraulic oil reservoir – maintain level via the
sight gauge.
Change engine oil and filter at least once annually, even if the
100 hours have not been met.
WEEKLY OR EVERY 40 HOURS OF OPERATING TIME
1. Clean the air cleaner following the instructions in the engine operator’s manual.
2. Lubricate all the points on the HydroSeeder
®
as outlined in DAILY of the CLEANING AND
MAINTENANCE section. Additionally, lubricate the grease fittings on clutch/pump.
3. Inspect slurry tank for build up of residue in suction area and clear if necessary.
Содержание HydroSeeder T30
Страница 4: ......
