22
APPLICATION OF SLURRY (CONTINUED)
II. PROCEDURES WHEN USING HOSES
Always pump clear water through hose before pumping mulch. If the inside hose liner is dry, it will
dewater the mulch, causing the hose to plug.
DISCHARGE THROUGH HOSE OR HOSE REEL WITH REMOTE VALVE
1. Open recirculation valve, close discharge valve, and close remote valve at the end of
hose.
2. With the engine at low idle, engage (turn on) the pump clutch by flipping the clutch toggle
switch [with the orange icon
(
)
] to the
ON
(
)
position (all the way up). When stream is
flowing freely through the recirculation line, open pump take-off valve.
The high pressure on the hose can exert strong forces, causing the
potential for the hose operator to lose control of hose or footing.
The hose will require additional hose holders when this operation occurs on slopes. Open
the pump take-off valve and the remote valve slowly and only after the hose operator is
firmly positioned and has firm control of hose. Failure to comply could result in minor
or moderate personal injury. Failure to comply could also result in product or property
damage.
3. With the engine at 3/4 speed, open the remote valve at the end of hose to discharge load.
4. When finished spraying, close remote valve, disengage (turn off) the pump clutch, and
stop engine. If using fiber mulch, retain as much water as possible in hose by elevating
the hose ends or by coupling the hose ends together.
5. If another load is to be done, see RELOADING PROCEDURE below. If finished for the
day, follow the clean-up procedure described in DAILY CLEANING AND MAINTENANCE
section and flush out the hose.
The recirculation valve must be open when using a remote valve.
Failure to comply will result in death or serious injury.
RELOADING PROCEDURE
1. Start at step 2 in LOADING PROCEDURE section.
2. After last load of the day, refer to CLEANING AND MAINTENANCE section.
Содержание HydroSeeder T30
Страница 4: ......
