Finn HydroSeeder T30, Инструкция оператора и каталог запасных частей

Страница: 37 / 73

31
TROUBLESHOOTING YOUR HYDROSEEDER
®
:
Problem Probable Causes Suggested Solutions
LEAKS:
Tank Bearing Lack of lubrication – seal worn Replace seal and follow lube
schedule.
Bolts not tightened Tighten uniformly to 25 lb–ft
(34 N•m).
Pressure Pipe Clamps Rubber seal cracked, pinched, torn
or missing. Replace, always grease seal
before clamping shut.
Suction Pipe Clamps Rubber seal cracked, pinched, torn
or missing. Replace, always grease seal
before clamping shut.
Pump Shaft Pressure lubricator not serviced Replace pump seal. Service
automatic pressure lubricator
daily.
Pump Suction Cover O-ring bad Replace O-ring; use grease
when replacing.
Discharge Hose or Nozzle
Camlock Fittings Worn or no gasket Replace gasket.
MACHINE JUMPS DURING OPERATION:
Agitator Agitator bent by heavy object
falling on it Straighten agitator shaft or
shim so it runs true.
Bent Paddles Loading wood fiber mulch into tank
before tank is half full Straighten agitator paddle;
realign agitator to run true.
FOAMING OF SOLUTION AND LACK OF DISTANCE:
Pump loses prime
– lacks distance
– leaves excessive amount in tank
[100 gallons (378 L) or more]
Sucking air through suction line Check all suction connections
to see that rubber seals are
in good shape. Grease seals
before replacing clamps.
Air entrainment See TROUBLESHOOTING
step 1.
Low engine RPM
(Below 2,750 RPM – No load) Check throttle cable and
linkage. See authorized engine
dealer.
Soft water Slow the agitator.
Too much agitation Slow the agitator.
Pump worn Reset pump tolerance.
Suction partially plugged Clean out machine.
Nozzle worn or plugged Clean nozzles; replace if
necessary
Fertilizer Change type.
Clutch slippage Replace clutch.