FST-DCP-1500-05 HIGH VOLTAGE POWER SUPPLY
2283
USER MANUAL
22/01/2010 12:52 PM
AT
UserManual FST-DCP-1500-05 HighVoltagePowerSupply 100122EN
ver1.doc
15/27
------------------------------------------------------------------
Finero Oy
–
The Quality Control Company
Tel. +358-5-7522 200
Haltonintie 5, FIN-47400 KAUSALA, FINLAND
Fax +358-5-3638 326
www.qacontrol.com
7 REMOTE CONTROL AND LOGIC OPERATION
7.1 General
This means a possibility to incorporate the Tester in a less sophisticated automatic test
system. The Tester operates as in the manual mode but has provision for extra output con-
tacts for indicators and logic inputs for the control buttons.
7.2 Start-up
Basically the Tester will be put into operation as in manual mode. In addition the wiring of the
operator connector at the rear is to be done. The connector is a 25-pin D-type female connec-
tor. In wiring diagram you'll find a diagram and wiring of the equipment ,which can be con-
nected to the connector. Maximum output from +25V are 300mA (7,5W)
7.3 Logic Connections
Contacts are available to show state of test and test result. Also there are two extra outputs,
which are possible programmed.
“Test On” output are on, when voltage
is on.
“Fail” output are on, when test current is higher than limit value. At the same time the test is
interrupted.
The connector has logic inputs like the start and stop buttons. Also there are two extra inputs,
which are possible programmed.
“Start”
signal switches the test voltage on.
“Stop” signal disconnects the test voltage.
The connector has inputs for the safety circuit, if circuit are open high voltage are not con-
nected.
