FST-DCP-1500-05 HIGH VOLTAGE POWER SUPPLY
2283
USER MANUAL
22/01/2010 12:52 PM
AT
UserManual FST-DCP-1500-05 HighVoltagePowerSupply 100122EN
ver1.doc
9/27
------------------------------------------------------------------
Finero Oy
–
The Quality Control Company
Tel. +358-5-7522 200
Haltonintie 5, FIN-47400 KAUSALA, FINLAND
Fax +358-5-3638 326
www.qacontrol.com
4 INSTALLATION
4.1 General
The Power Supply is designed for standard 19" rack or case. Height is 3U (133 mm). Depth is
about 370 mm and connectors need about 150mm space from rear. The handles mounted on
the front panel are elevated about 40 mm from the panel. The Power Supply is not allowed to
carry from the handles but by having a stable hold in the frame.
The Power Supply can be used in its own case only in dry and clean environment but care
must be taken nothing goes into the case through ventilation openings. The ventilation,
however, should not be prevented.
4.2 Mounting into 19” module –
rack or case
When installed into a rack or a similar case it is mandatory to use mounting rails due to the
weight of the device. The holes in the front panel are intended for locking the device in its
place not for backing the whole device. If there are legs below of tester, they must take off
before installation to 19” rack. Care must be taken of the air circ
ulation in the rack in order to
avoid temperature rise above +35°C.
Here are some examples of how build the support for rack installation.
