Fife SBPC-21-EN, Инструкция для пользователя, Страница: 24 / 44

Hardware Configuration – Multiple CDP-01’s
In the network below, the default SBPC-21-EN configuration is used multiple times to provide control to
multiple CDP-01’s. Each SBPC-21-EN is connected to a single CDP-01 creating a separate FifeNet
network for each CDP-01. Each SBPC-21-EN appears as both a FifeNet node and an Ethernet node.
Notice the SBPC-21-EN Ethernet address must be different for each SBPC-21-EN. The Ethernet
address is set by dipswitches inside the enclosure or by configuration during a TELNET session.
Figure 3-2: SBPC-21-EN Network Connection with Multiple CDP-01’s
FifeNet
Customer
Ethernet
Ethernet Hub
FifeNet
FifeNet Master
Address 10
Ethernet
IP Address
192.168.0.2
FifeNet Master
Address 10
Ethernet
IP Address
192.168.0.1
SBPC-21-EN to
CDP-01 Cable:
Fife P/N 68554-001
FifeNet
Address 1
FifeNet
Address 1
Software Configuration
Configurations have been created to match the single CDP-01 network shown in Figure 3-1. Since the
CDP-01 can have one, two, or three drives, a configuration has been created to match the parameters
present in each drive configuration. The three configurations are:
Table 3-1
CONFIGURATION
SBPC-21-EN
MATRIX
CDP-01
MATRIX
SBPC-21-EN Default Matrix for use with Single-Drive CDP-01 100410-02X 100246-02X
SBPC-21-EN Default Matrix for use with Dual-Drive CDP-01 100411-02X 100247-02X
SBPC-21-EN Default Matrix for use with Triple-Drive CDP-01 100412-02X 100248-02X
07-02-2004
Figure Sheet 1-849-C Page 18