FHP AHP 641-224, Руководство пользователя, Страница: 8 / 42

8
PROTOCOLS SW3 SW4
BACnet
®
MS/TP
Off Off
N2 On Off
Modbus Off On
Option Card On On
Typical DIP switch for LonTalk® (Option
Card) is shown in figure 8.
Jumpers and settings
Controllers come equipped with a series of
jumpers which allow different types of inputs
to be terminated in a particular point.
Most inputs allow thermistor or dry contact
input devices to be terminated in them,
however IN1 and IN2 can be used as analog
or digital input points and their available
options are as follows:

0-5 VDC Analog Input
 Thermistor

Dry Contact
FHP sets most switches in the factory,
however there are certain cases where a
particular sensor is required by the
customer, therefore it is important for the
installer to understand jumper settings and
their relationship with unit configuration and
operation. Figure 9 shows the location of the
jumpers on the controller.
Figure 8 - LonTalk® DIP Settings
EIA-485
BACnet
over ARC156
Figure 9 - Jumper setting for LonTalk
® only.
Figure 10 - Jumper Settings
1
2
3
4
IMPORTANT:
The
LonTalk® card
must be installed.
Jumpers set up will be
cover under the jumper
section.
ON