Festo MS6-SV-***-E-ASIS Series, Руководство по эксплуатации

Страница: 35 / 60

MS6(N)-SV-...-E-ASIS
Festo – MS6(N)-SV-...-E-ASIS – 1205NH English 35
2 Requirements for product use
• Make these operating instructions available to the design engineer and installer of the machine or
system in which this product will be used.
• Keep these operating instructions during the entire product life cycle.
• Take into consideration the regulations applicable for the destination, as well as:
– regulations and standards,
– regulations of the testing organizations and insurers,
– national specifications.
2.1 Technical requirements
General conditions for the correct and safe use of the product, which must be observed at all times:
• Maintain the specified limits (e.g. for pressures, temperatures and electric voltages).
• Make sure there is a supply of correctly prepared compressed air in accordance with the specifica-
tions on the medium.
• Before mounting, remove particles in the supply lines through appropriate measures. In this way,
you protect the product from premature failure and higher wear.
• Pressurize your entire system slowly. This allows avoidance of abrupt movements.
• Observe the warnings and instructions in these operating instructions.
• Use the product in its original status, without any unauthorised changes.
2.2 Qualification of trained personnel
Installation, mounting, commissioning, maintenance, repair and removal from operation may only be
performed by qualified personnel with knowledge and experience with electrical and pneumatic control
technology.
AS-Interface bus systems may only be installed by personnel especially trained for this purpose. Spe-
cifications on the design and addressing of your bus system can be found in the description of your AS-i
master.