Festo CPA-SC Series, Руководство пользователя

Страница: 115 / 140

5. Maintenance and conversion
5−13
Festo P.BE−CPASC−EN en 0808c
8. Cover the valve location or fit equipment into it.
Protect an unused valve location with a blanking plate
and the electrical contacts with the cover foil supplied
with the set.
If only channel (1) is separated, the valve location in
which the fastening pin is located can be fitted with a
valve sub−base (in the example in VP 5). If however,
channels (3) and (5) are separated, the VP 5 must be
fitted with a blanking plate.
9. In order to mark the channel separation, clip an identifica
tion plate onto the relevant position in the base block.
Note
Note that due to the separator element in the following
valve locations, the valve sub−bases have up to 20 % less
flow:
the valve location with the fastening pin
and the two neighbouring valve locations
(in the example VP 4 and VP 6).
Dismantling
1. Loosen the separator element (in Fig.5/2 position
4
)
with the hexagon socket wrench.
2. Remove the fastening pin (in Fig.5/2 position
5
) from
the base block.
3. Push the separator element out of the appropriate
channel of the base block.