Festo CMGA-E1-PB, Перевод оригинальной инструкции

Страница: 10 / 16

CMGA-E1-PB
10 Festo – GDCP-CMGA-E1-PB-EN – 1201NH
4.3 Device settings
The following can be set on the front side of the module:
1
Coding switch, bus
termination
2
Diagnostics LEDs
3
PROFIBUS plug connector
4
PROFIBUS address switch
1
2
3
4
Fig. 8 Front CMGA-E1-PB
4.3.1 Address wheels
Input of the Profibus address in hexadecimal.
Example address Hexadecimal ADDR HIGH ADDR LOW
5 05 0 5
46 2E 2 I
Tab. 4 PROFIBUS address
4.3.2 Coding switch
Terminating resistors for CAN bus connection:
Coding switch Description
1
2
ON
Switch 1 120 ohm terminating resistor on backwall of CAN
Switch 2 120 ohm terminating resistor 2nd CAN-interface via SUB-D socket
Tab. 5 Coding switch, terminating resistors
4.4 Diagnostics
LED Colour Mode Description
RUN Green “Flashing” Module OK
DP Green “Permanent” Profibus connection active
Green “Flashing” Profibus connection interrupted
Red “Flashing” Transferred parameter data invalid
XB Green “Flashing” “Internal” CAN telegram (CMGA) is being received
Red “Flashing” Missing CAN telegram or CAN telegram not within the
“CAN WD Timeout” time
Tab. 6 LED display