Festo 8060571, Инструкции по ремонту

Страница: 33 / 52

33 / 52 Festo 7ELCC_TB_KFb_en
3. Unscrew the socket head screws (4x) from the end plate, at the same time,
fix the spacing bolt with an open‑ended spanner.
4. Secure the end plate with roller and toothed belt pulley modules against
falling.
On removing the end plate with roller and toothed belt pulley modules,
secure the top shims (2x) of the roller modules to prevent loss.
5. Carefully remove the end plate with roller and toothed belt pulley modules.
6. Secure shims (2x).
On removing the roller and toothed belt pulley modules from the end plate,
secure the bottom shims (2x) of the roller modules to prevent loss.
7. Remove the roller modules (2x) and toothed belt pulley module from the
end plate.
8. Secure shims (2x).
9. Check the roller and toothed belt pulley modules for wear

replace if
necessary (  Chapter 5.3 on page 33 ).
5.3 Mounting the roller and toothed belt pulley modules
Note
ELCC-TB-KF-60 / 70-…-M1
The sensor bracket with measuring unit for these types is mounted on the end plate.
• On mounting the end plate, avoid damaging the measuring tape on the cylinder barrel module.
Note
ELCC-TB-KF-70 only
The toothed belt pulley module is not symmetrical, the side with the larger
overhang of the toothed belt pulley beyond the deep-groove ball bearing
must face the slide module.