Ferrari Costruzioni Meccaniche GREENCAM TSA-40, Инструкция по эксплуатации и техническому обслуживанию

Страница: 13 / 80

OPERATING INSTRUCTIONS AND MAINTENANCE 2020
Pagina 13 di 80
•
When attaching the machine to the three-point tractor lift,
check that the head pins' diameters are suitable for the
diam
eter of the tractor’s kneecaps.
•
Warning: in the area of the three-point lift there is a risk of
crushing your fingers and cutting yourself!
•
Do not entertain in the area between the tractor and the
machine when using the external lever to control the lift.
•
During the transport of the machine in the raised position,
lock the control lever of the lift.
3.2 HYDRAULIC CIRCUIT
•Before connecting a hose to the tractor hydraulic circuit,
ensure that the tractor and machine side circuits are not under
pressure.
• The pipe fittings are protected b y rubber plugs. When the
machine is disconnected from the tractor, it is recommended
to place the protection caps on the couplings. When the
machinery is connected to the tractor, the plugs remain
attached to the pipes by means of a ring so that they can be
repositioned at the next stop.
• In the event of damage to, loss of, or replacement of, the
caps, it is recommended that the caps of appropriate size be
reassembled.
• Attention: the operation of connecting the pipes t o the
tractor circuit is of fundamental importance for safety during
the use of the machine.
• Pay particular attention to mating. However, the risk of
function inversion remains (for example, lifting and lowering
functions can be mistakenly exchanged).
• In the case of inversion, exchange two tubes with caps of the
same colour.
• Periodically check the hydraulic hoses! Damaged or used
hoses must be immediately replaced. New pipes must have the
characteristics and quality prescribed by the manufacturer of
the machine (contact our technical service).
• If a leak is detected, immediate action must be taken to
prevent accidents.
• All fluids under pressure, especially the oil of a hydraulic
circuit, can cause even serious injuries to the skin! In case of
injuries, consult a doctor immediately: there may be danger of
infection!
• Before turning on the hydraulic circuit, lower the machine,
remove pressure to the hydraulic circuit, stop the tractor
engine and remove the key from the ignition.
• Hydraulic connection s between tractor and machine must be
disconnected and secured during road transport.
3.3 INSTRUCTIONSFOR THE CORRECT USE OF THE
MACHINERY
If you have already read carefully the "part 2" of this manual,
which covers the main safety requirements,
you can switch to the actual user manual, within which you will
find basic information for the correct use
of the machine, both from an operational and security point of
view.
3.3.0 COUPLING TO THE TRACTOR
•
Check the tyre pressure of the tractor and the front and
rear wheelbases (the front and rear dimensions must be
approximately equal).
•
The distances between points B and D of the tractor must
be equal on the right and left sides of the tractor, leaving
them slightly movable to the side. The lower tractor arms
(D) shall be adjusted so that the distances from the ground
are equal on the right and left sides.
•
Bring these arms to an appropriate height so that the
machinery is lifted sufficiently from the ground.
•
Regularly attach the hydraulic lift coupling device to the
tool.
Fig. 7: coupling tractor- machine
3.3.1 UNHOOKING FROM THE TRACTOR
Releasing the machine from the tractor is a very dangerous
phase.
Be very careful to perform the entire operation following the
instructions.
For a correct unhooking of the machine it is important to
operate on a horizontal plane
.
•
Insert the support feet.
•
Slowly lower the machine until it is completely on the
ground.
•
Loosen and unhook the third point, to follow the first and
second.