Fermax DUOX RELAY, Руководство по установке, Страница: 7 / 68

Page 7
The functions implemented on the relay are summarised below.
Functions implemented in TX Mode :
- Lock-release function after receiving a call.
- Lock-release function to a confi gured panel.
- Guard-unit call function.
- F1 relay activation or deactivation function.
- F2 relay activation or deactivation function.
- Remote relay activation or deactivation function.
- Doormatic function.
Functions implemented in RX Mode :
- Activating the relay upon receiving a lock-release command.
- Activation upon receiving a guard-unit call command.
- Activation upon receiving a call to residence command from a panel.
- Activation upon receiving an Auto-start command.
- Activation upon receiving an Activate F1 relay command.
- Activation upon receiving an Activate F2 relay command.
- Activation upon receiving an Activate/Deactivate relay command.
Note:
- Whenever terminals from different blocks are required to activate the same relay, it must be
confi gured as General Entrance.
Other confi gurations :
- Confi guration of activation times via integrated push-buttons.
- Resetting Parameters.
7. PRG : Programming Access button.
8. Min/All - Sec/Single: Buttons for Functions and Activation Times
- For Functions: In combination with the PRG button (programming input), they are
pressed to program the relay’s different possible functions.
- For activation times.
* Timed: This allows you to confi gure the activation time between 1 and 120 seconds
in the seconds range and between 1 and 120 minutes in the minute range.
* Continued: Allows the relay to be confi gured to keep the contact closed until
deactivation occurs by means of a short-circuit between the RESET and -.
9. C, D, T: LED diodes that give information when programming, relative to the status: off,
on, fast fl ash...etc.
10. Telephone Connector: For the DUOX Programmer connection.
1.1 FUNCTIONS / CONFIGURATIONS
VERY IMPORTANT NOTE:
Even though the relay is implemented on all functions detailed below, SOME functions may
not yet be applied because the devices used for this will be available in the future.