Ferm TDM1022, Оригинальное руководство пользователя

Страница: 6 / 36

EN
6 Ferm
Wear eye and ear protection.
During use the following points must be
considered:
• Do not remove any mechanical or electrical
protective provisions.
• Check whether all the protective provisions
are in place and have been attached correctly.
• Wear safety goggles during drilling.
• If you have long hair, be sure to wear hair
protection (hair net or cap). Long hair can
easily be caught in moving parts.
• Wear fitted clothing; tie buttons on sleeves.
• Do not hold any workpieces in your hands
when drilling. Always use a machine clamp or
another clamping tool.
• Protect workpieces and clamping tools on the
bench to prevent them from getting caught.
Fasten them yourself with screws or clamp
them to a machine clamp fastened to the
table.
• Check whether the drill holder is tightened
properly.
• Check whether cable lead-throughs are okay.
• To remove drill chips only use hand brushes,
brushes, rubber wipers, chip hooks or similar
aids.
• Do not carry out any cleaning or greasing work
while the machine is in operation.
• Always keep V-belts covered (so that your
hands cannot become caught).
• Only tighten the toothed ring drill holder by
means of the wrench.
• Never leave the wrench of the drill holder in
the drill holder! Before switching on the
machine, check whether the wrench really has
been removed!
• Do not use any drills which are damaged on
the shank.
• Drill is not suitable to use as press!
• If the mains cable is damaged, it may only be
replaced by a mains cable of the same type.
Immediately switch off the machine when:
• Interruption in the mains plug, mains lead or
mains lead damage.
• Defect switch.
• Smoke or stench of scorched isolation.
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Always check that the power supply
corresponds to the voltage on the rating
plate.
The machine is provided with a zero
voltage switch. After the tension drops
the machine will not start to run
automatically for safety reasons. The
machine must be switched on again.
Replacing cables or plugs
Immediately throw away old cables or plugs when
they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in the
wall outlet.
Using extension cables
Only use an approved extension cable suitable for
the power input of the machine. The minimum
conductor size is 1.5 mm
2
. When using a cable
reel always unwind the reel completely.
3. Assembly
Fig. B
• Place the footplate (13) in the correct position.
• Fasten the column (11) with the bolts supplied
(12) to the footplate.
• Now slide the table holder (10) with the table
over the column (11). With the fastening
handle (6) the table is fastened into the
desired position.
• Now you can assemble the machine casing
(7) and lock with the locking pins (8).
• Since the drill spindle is greased in the factory,
it is advisable to run in the machine for
approximately 15 minutes at the lowest speed.
Before you push the chuck with pin (9)
into the drill spindle, the inside of the
chuck must be completely grease-free!
Setting up the bench drill
Before use the drill must be mounted on a fixed
base. The footplate (13) has therefore been
provided with drilling holes. By means of screws
the footplate can be fixed to the base in this place.
If it is mounted on a wooden board, sufficiently
large washers must be used on the opposite side,
so that the bolts are not pushed into the wood and