Fenix EPC1800, Руководство по эксплуатации

Страница: 26 / 53

EPC1800 SERIES OPERATION MANUAL
[Description] Sets the character spacing for the right side of the character to [ n x 0.125 mm ( n x
0.0049”)].
[Notes]
●
The right side character spacing for double-width mode is twice the normal value.
● This command is effective only when sent at the beginning of a line.
[Default] n = <04>H
ESC DC2 GS BEL
[Name] Save current settings into non-volatile memory
[Format] ASCII ESC DC2 GS BEL
Hex 1B 12 1D 07
Decimal 27 18 29 07
[Description] Saves current configuration into flash memory so when the printer is restarted, current
configuration will be loaded.
[Notes] The parameters that will be saved are line spacing, character spacing, character table,
character width and height.
ESC DC3 GS BS
[Name] Save default settings into non-volatile memory
[Format] ASCII ESC DC3 GS BS
Hex 1B 13 1D 08
Decimal 27 19 29 08
[Description] Saves default configuration (factory settings) into flash memory so when the printer is
restarted, default configuration will be loaded.
[Notes] The parameters that will be saved are line spacing, character spacing, character table,
character width and height.
ESC ! n
[Name] Select print mode(s)
[Format] ASCII ESC ! n
Hex 1B 21 n
Decimal 27 33 n
[Range] <00>H
≤
n
≤
<FF>H
[Description] Selects print mode(s) using n as follows:
Bit OFF/ON Hex Function
0 OFF 00 Character font A (12 x 24).
ON 01 Character font B (8 x 16).
1 -- -- Undefined.
2 -- -- Undefined.
3 OFF 00 Emphasized mode not selected.
ON 08 Emphasized mode selected.
4 OFF 00 Double-height mode not selected.
ON 10 Double-height mode selected.
5 OFF 00 Double-width mode not selected.
ON 20 Double-width mode selected.
6 -- -- Undefined.
7 OFF 00 Underline mode not selected.
ON 80 Underline mode selected.
[Notes]
●
When both double-height and double-width modes are selected, quadruple-size
characters are printed.
●
When some characters in a line are double or more height, all the characters in the
line are aligned at the baseline.
●
ESC E can also select the emphasized mode. Be careful when uses both command.
●
ESC M can also select character font type. However, the setting of the last received
command is effective.
●
GS ! can also select character size. However, the setting of the last received
command is effective.
26 of 53