Fenix Imvico TK23 Series, Руководство по эксплуатации

Страница: 43 / 81

FENIX IMVICO TK23 OPERATION MANUAL
43/81
LF
[Name] Print and line feed
[Format] ASCII LF
Hex 0A
Decimal 10
[Description] Prints the data in the print buffer and feeds one line, based on the current
line spacing.
[Note] This command sets the print position to the beginning of the line.
[Reference]
ESC 2
,
ESC 3
.
CR
[Name] Print and carriage return
[Format] ASCII CR
Hex 0D
Decimal 13
[Description] When automatic line feed is enabled, this command functions the same as
LF
; when automatic line feed is disabled, this command is ignored.
[Notes]
•
This command is set at the start-up, via the PROGRAMMING MODE (see
point
3.4.2- PROGRAMMING MODE
).
•
Sets the print starting position to the beginning of the line.
[Reference]
LF
DLE EOT n
[Name] Real-time status transmission
[Format] ASCII DLE EOT
n
Hex 10 04
n
Decimal 16 4
n
[Range] <01>H
≤
n
≤
<04>H
[Description] Transmits the selected printer status specified by
n
in real-time, according
to the following parameters:
n
= <01>H: Transmit printer status
n
= <02>H: Transmit offline status
n
= <03>H: Transmit error status
n
= <04>H: Continuous paper sensor status
n
= <05>H: Paper sensor status
[Notes]
•
The status is transmitted whenever the data sequence <10>H<04>H<n>
( <01>H
≤
n
≤
<05>H) is received.
•
The printer transmits the current status. Each status item is represented by
one-byte of data.
•
The printer transmits the status without confirming whether the host computer
can receive data (in serial interface).
•
The printer executes this command upon receiving it.
•
This command is executed even when the printer is offline, the receiver buffer
is full, or there is an error status with a serial interface model.
•
If a not recovery error occurred, the bit 2 in the Printer Status (
n
=1) will be
indeterminate.