FENIX IMVICO
TK23 OPERATION MANUAL
54/81
•
pL
and
pH
specifies the number of bytes of the parameters (always 4).
•
a
specifies setting values for the positions to start printing and cutting.
A
Function
<01>H
Setting value for the positions to start the printing
<02>H
Setting value for the positions to start the cutting
•
m
specifies the direction of the adjustment.
M
Function
<00>H
Specifies a forward paper feeding direction
<01>H
Specifies a backward paper feeding direction
•
nL
and
nH
specifies the setting value to [(
nL
+
nH
x 256) x 0.125 mm].
•
The adjustment value for the print starting position (
a
= <01>H) is affected
with the following commands:
GS FF
•
The adjustment value for the paper cutting position (
a
= <02>H) is affected
with the following commands:
GS V m n
[Notes]
The offset for the print starting position is refered to the offset of the
cutting position, Offset for cutting position is always refered to the
Optical Mark.
[Default]
By factory default setting, the cutting position is set to 200 forward
and the printing position is set to 100 backward:
paper begins exactly
at the position of the paper optical mark (where the optical mark sensor
makes the detection). See point
3.6- OPTICAL MARK
.
[Reference]
GS FF, GS V
GS ( K 2 0 0 m
[Name]
Select the energized mode.
[Format]
ASCII
GS ( K
2 0 0 m
Hex
1D 28 4B 02 00 00
m
[Range] <01>H
≤
m
≤
<02>H
[Description]
•
m
specifies the print control mode.
m
Function
<01>H
Specifies the non-divided print head energizing mode.
<02>H
Specifies the two-part print head energizing mode.
[Notes]
When this command sets the two part energized mode (m = <02>H), the maximum
printing speed (150mm/s) is automatically prohibited.
[Default]
m
= <01>H
[Reference]
GS E, PROGRAMMING MODE
