Felisatti AG115/1000, Руководство по эксплуатации

Страница: 7 / 49

6
TECHNICAL DATA
Read the operating instructions
Protection category II power tool; double
insulated
In accordance with essential applicable safety
standards of European directives
In accordance with essential applicable safety
standards of Russian Federation
Wear eye protection
Follow very carefully the instructions in this manual,
save it and keep it close at hand, ready to carry out any
inspection of parts that may be necessary.
If the tool is used with care and normal maintenance is
carried out, it will work well for a long time.
The functions and use of the tool you have bought
shall be only those described in this manual. Any other
use of the tool is strictly forbidden.
ILLUSTRATIONS
DESCRIPTION (See figures)
1 Start-up switch (Fig.1)
2 Auxiliary handle (Fig.1)
3 Disc guard for sanding operation (Fig.1)
4 Disc guard for cutting-off operations (Fig.1)
5 Spindle (shaft) (Fig.1)
6 Spindle blocking button (Fig.1)
7 Support plate (Fig.1)
8 Abrasive disc (Fig.1)
9 Clamping nut (Fig.1)
10 Pin spanner (Fig.1)
11 Clamping plate (Fig.1)
12 Screw (Fig.1)
13 Screw (Fig.1)
EQUIPMENT
- Disc guard (for sanding operation)
- 1 auxiliary handle
- 1 pin spanner
- Disc clamping nuts
- Operating instructions with Safety instructions
- Warranty
BRIEF DESCRIPTION
This angle grinder has been designed for cutting,
deburring and cutting metals and stone without the use of
water.
BEFORE USING THIS TOOL
Before using the tool, make sure the mains voltage
is correct: it must be the same as that on the specification
label. Machines with 230V can also be connected to a
220V mains supply.
FITTING SAFETY DEVICES
WARNING! Always unplug the machine before
carrying out work on it.
1. Fitting the disc guard
To change the disc guard unscrew 4 screws 12 and 13
from clamping plate of guard 11 , take off the guard, place
another guard, place the clamping plate matching holes of
the guard and of the clamping plate, tight screws.
The guard can be rotated around the spindle. For this:
- loosen the screw 13 of the guard;
- rotate the guard in the position excluding spark
emission in direction of operator;
- tight the screw 13 .
WARNING! The closed part of the disc guard should
always point towards the user.
2. Fitting the auxiliary handle 2
Use of the auxiliary handle is obligatory in order to
ensure greater control and safety when handling the tool.
The auxiliary handle 2 must be screwed on to the right or
left side, depending on the type of work to be carried out.
FITTING THE ACCESSORIES (DISCS AND WHEELS)
WARNING! For safety reasons, the machine should
always be unplugged from the mains before changing the
disc or wheel. Always work with the guard on and wear
safety goggles.
Use deburring and cutting discs with fibre-reinforced
synthetic binders, for a max. peripheral speed of 80 m/s
and cup wheels with synthetic binder for 45 m/s. Protect
discs and wheels from knocks and blows.
WARNING! Never press the blocking button when
the machine is running. The shaft must have stopped com-
Angle grinder AG115/1000 AG125/1000
Voltage V~ 230
Frequency Hz 50-60
Input power W 1010
No-load speed min
-1
11000 11000
Max. disc diameter mm 115 125
Inner disc diameter mm 22.2 22.2
Spindle thread ISO M14 M14
Weight according EPTA-Procedure 01/2003 kg 2.4 2.45