OBID
®
classic-pro
Manual
ID CPR.03.20-CD
FEIG ELECTRONIC GmbH
Page 12 of 40
H60100-5e-ID-B.doc
3.3. Configuration Procedure
Configuration is carried out by means of a ConfigCard. An ISO 15693 transponder can be used as
ConfigCard (e.g.
Infineon my-d: SFR55V10P, Philips I-CODE SLI, Texas Instruments TagIT HFI etc.)
The configuration data are stored in a specified read/write data block on the transponder. The
ConfigCard is also coded with identifiers which enable recognition as a ConfigCard.
The creation and modification of a ConfigCard could be done by the FEConfigCardTool which is
available for Windows operating systems.
3.3.1.
Default Configuration
The factory configuration of the reader is as follows:
•
Reads serial numbers (UID) from ISO 14443 Type A, ISO 14443 Type B and ISO 15693 trans-
ponders.
•
Data output: Magstripe Track II, binary (80-bit) format.
3.3.2.
Reloading the configuration
1.
Switch on the power supply.
2.
Hold the ConfigCard in the reading range during the configuration phase (8 seconds). During
this time the red and green LEDs flash alternately.
3.
After the configuration is complete the reader automatically switches into normal mode.
Signals:
The reader acknowledges a ConfigCard with the following signals:
1 x LED green + Beeper (1 sec.)
⇒
OK
ConfigCard has been processed, reader is operating with the new configuration
2 x LED red + Beep
⇒
Fault
ConfigCard CRC16 or ConfigCard Identifier is not read correctly.
⇒
Repeat procedure.
⇒
Check the ConfigCard for correct programming.
Note:
The ConfigCards are only recognized by the reader if the AFI is correct set.
No signaling is possible.