ORIGINAL INSTRUCTIONS > EN
( 7 ) Battery- Used to start the engine electrically
( 8 ) Power Panel- See " Power Panel " section
( 9 ) Fuel Selector Switch- Used to select fuel source
3. ASSEMBLY
Your generator requires some assembly. This unit is shipped from our factory without oil. It must be
properly serviced with fuel and oil before operation.
Remove the Generator from the Shipping Carton
1. Set the shipping carton on a solid, flat surface.
2. Remove everything from the carton except the generator.
3. Carefully cut each corner of the box from top to bottom. Fold each side flat on the ground to provide a
surface area to install the wheel kit and support leg.
Install the Wheel Kit
CAUTION:
The wheel kit is not intended for over-the-road use.
You will need the following tools to install the wheels:
• Wheel bolt
• Needle
1. Before adding fuel and oil, tip the generator on its side.
2. Slide the Roll Pin(B) through the wheel (A) from the outside
3. Slide the Roll Pin through the mount point on the frame.
4.Secure with the R-Cilp(C).
5. Repeat the above steps to attach the second wheel.
Install the Support Leg
1. Attach the support leg to the generator frame with flange bolt (M8x16) and flange lock nuts (M8).
2. Tip the generator slowly so that it rests on the wheels and support leg.
08
