ORIGINAL INSTRUCTIONS > EN
Once a fuel source has been selected, the user must turn the fuel valve to the vertical position to open the
fuel valve. (1)
To turn a fuel valve to the off position the valve must be in the horizontal position. (2)
NOTE
The fuel selector switch cover is specifically designed not to slide to either side while a specific fuel has
been selected and the valve is in the “ON” position. Only when the fuel valves are in the “OFF” position can
the cover slide side to side.
NOTE
The fuel selector is locked into place once a “CLICK” sound is made. Only then can a fuel valve be turned
to the vertical position.
Starting the Engine in ambient > 15°C (59°F)
Gasoline
1. Make certain the generator is on a flat, level surface.
2. Disconnect all electrical loads from the generator. Never start or stop the generator with electrical
devices plugged in or turned on.
3. Turn the gasoline fuel valve to the “ON” position.
4. Move the choke lever to the “100% CHOKE” detent position.
a. For restarting a warm engine, move the choke lever to the “75% CHOKE” detent position.
5. Push the ignition switch to the “ON” position.
6. Push the battery switch to the “ON” position.
7. ELECTRIC START: Press and hold the ignition switch to the “START” position. Release as the engine
begins to start, if the engine fails to start within five seconds, release the switch and wait at least ten
seconds before attempting to start the engine again.
8. RECOIL START: Pull the starter cord slowly until resistance is felt and then pull rapidly.
9. Do not over-choke. As soon as engine starts, gradually move the choke lever to the “RUN” position over
2-5 second.
14
