2562244A
REV. A 606
Printed in U.S.A.
INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS
FOR
VISIBEAM® II WIRELESS, REMOTE CONTROLLED SPOTLIGHT
SAFETY MESSAGE TO INSTALLERS AND USERS
People’s lives depend on your safe instal-
lation of our products. It is important to
read, understand and follow all instruc-
tions shipped with the products. In addi-
tion, listed below are some other important
safety instructions and precautions you
should follow:
• To properly install this kit: you must
have a good understanding of automo-
tive electrical procedures and systems,
along with proficiency in the installa-
tion and use of safety warning equip-
ment.
• DO NOT install equipment or route
wiring or cord in the deployment path
of an air bag.
• When drilling into a vehicle structure,
be sure that both sides of the surface
are clear of anything that could be
damaged.
• In order for the light to function prop-
erly, a separate ground connection
must be made. If practical, it should
be connected to the negative battery
terminal. At a minimum, it may be at-
tached to a solid metal body or chas-
sis part that will provide an effective
ground path as long as the light system
is to be used.
• Locate light control so the VEHICLE
and CONTROL can be operated safely
under all driving conditions.
• Do not attempt to activate or deacti-
vate light control while driving in a
hazardous situation.
• You should frequently inspect the light
to ensure that it is operating properly
and that it is securely attached to the
vehicle.
• File these instructions in a safe place
and refer to them when maintaining
and/or reinstalling the product.
Failure to follow all safety precautions and
instructions may result in property damage,
serious injury, or death to you or others.
Changes not expressly approved by the party
responsible for compliance could void the user’s
authority to operate the equipment.
Note: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a res-
idential installation. This equipment generates,
uses and can radiate radio frequency energy
and, if not installed and used in accordance with
the instructions, may cause harmful interfer-
ence to radio communications. However, there is
no guarantee that interference will not occur in
a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equip-
ment and receiver.
- Connect the equipment into an output on a
circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV
technician for help.
This product complies with FCC radiation expo-
sure limits set forth for an uncontrolled environ-
ment.
I. UNPACKING.
After unpacking the unit, inspect it for damage
that may have occurred in transit. If the unit has been
damaged, file a claim immediately with the carrier,
stating the extent of damage. Carefully check all
envelopes, shipping labels, and tags before removing
or destroying them. Ensure that the parts listed in the
appropriate KIT CONTENTS LIST are contained in the
package.
