290A5572
RIGHT
LEFT
DOWN
LAMP ON-OFF
UP
TRANSMISSION
INDICATOR LIGHT
Figure 5.
the magnet as necessary. Keep the area around the
magnetic mount light free of dirt and metal shavings.
3. Apply a film of light grease to the gears
when necessary.
Figure 6.
B.
Lamp Replacement (see figure 7).
A serious injury may result if lamp is
touched when hot. Always allow lamp to
cool before removing. Halogen lamps are
pressurized and if broken can result in
flying glass. Always wear gloves and eye
protection when handling the lamps.
Service life of lamp will be shortened if glass
portion is touched. If glass has been handled,
clean carefully with a grease solvent.
1. Move the reflector until the back of the
lamp is easily accessible.
2. Disconnect the lamp connector.
3. Release the lamp spring clip by pressing
inward and to the side on the lamp spring clip ends.
4. Remove the lamp by pulling it away from
the reflector and past the vertical motion cable and
spring clip.
5. Replace the lamp by performing the above
steps in reverse order.
C.
Mechanism Removal for Servicing (see figure 8).
1. Disconnect power to the light.
2. See figure 1. Push and hold the dome
release button (located in the plastic base). Turn the
dome counterclockwise and lift the dome off the base.
3. Disconnect the positive and negative wires
which exit the light.
LAMP
CONNECTOR
LAMP SPRING
CLIP (PUSH
AND MOVE
SIDEWAYS TO
RELEASE)
290A5574
MECHANISM
COVER
VERTICLE
MOTION
CHAIN
LAMP
Figure 7.
-5-
290A5573
HOLD UNIT VERTICAL FOR MAXIMUM RANGE
