II. KIT CONTENTS LIST.
All Surface Mount Models
Qty.
Description
3 Screw, #10, Hex
3 Flat Washer, #10
1 Gasket, Mounting
1 Battery cover/ belt clip
1 #4 self tapping screw
All Magnetic Mount Models
Qty.
Description
1 Cover, Magnet
1 Label, Caution
1 Battery cover/ belt clip
1 #4 self tapping screw
III. DESCRIPTION .
The wireless VisiBeam provides work light that can
be adjusted remotely. It can be rotated horizontally, 360
degrees continuously. It can elevate from 35 degrees
down to 105 degrees up . The wireless remote uses 2
AA batteries, and has a range of approximately 125
feet. The wireless VisiBeam has the capability to be
programmed to read the signals from up to 4 different
transmitters.
IV. LIGHT INSTALLATION.
A.
Surface Mount Models.
To install the light, proceed as follows:
1. Position the vehicle on a level surface.
Select a relatively flat mounting position which provides
sufficient rigidity to support the light and reduce
vibrations caused when the vehicle is in motion.
2. Push and hold the dome release
button (located in the plastic base). Turn the dome
counterclockwise and lift the dome off the base (see
figure 1).
Turning reflector by hand may damage motor or
worm gear. To rotate the reflector, connect to an
appropriate power source.
3. Position the light with the dome release
button toward the rear at the selected mounting
location.
NOTE
If the installer finds that the light mechanism
is in the way, it may be removed as described in
Section VI. C.
MOUNTING
HOLE
FRONT
SLIDE TO
REMOVE
INSERT TOOLS HERE TO
REMOVE MECHANISM
MOUNTING
HOLE
TWIST DOME
REMOVE
INSTALL
MOUNTING
HOLE
WIRING HOLE
MECHANISM
COVER
PUSH TO
RELEASE
DOME
290A5568
Figure 1.
4. Use the base of the light as a template and
scribe three mounting hole drill position marks on the
mounting surface. Also, scribe one wire routing hole drill
position mark at the center. See figure 1 for a diagram.
To avoid damage when drilling, ensure that both
sides of mounting surface are clear of any parts
or wires. Also, when drilling any holes, ensure
that holes are drilled only through sheet metal
and not through upholstery.
5. Drill one 3/8” (0.375”) hole (wire routing
hole) at the previously scribed center drill position
mark. Drill three 9/64” (0.140”) holes (mounting holes)
at the previously scribed mounting screw position
marks.
6. To protect the wires from abrasion and
shorting, smooth the edges of the 3/8” wire routing hole.
A user supplied grommet should be installed in the 3/8”
wire routing hole.
7. See figure 2. Align the holes in the
mounting gasket with the appropriate holes in the base
and apply the mounting gasket to the base of the light .
Route the light’s wires through the gasket’s wire routing
hole and through the mounting surface.
8. If the screws and/or wires enter a
compartment that is to remain dry, apply a silicone
sealing compound around the screws and wires where
they pass through the mounting surface to prevent
leakage.
9. See figure 2. Secure the base to the
mounting surface with the three #10 thread-forming
screws and flat washers.
10. Replace the mechanism after securing
the base, by aligning the narrower front tabs with the
-2-
