HUL-LED25WRE-12.3-50GCR-24I
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
2
45W Handheld LED Spotlight w/ 50' 12/3 SOOW Cord Reel & Inline Transformer
100-277VAC to 24VDC
Instruction Manual
Do not attempt operation until you are familiar with all warnings, precautions, and procedures outlined within this
instruction sheet.
Read carefully before operating. Retain these instructions for future reference.
WARNING:
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE
REFERENCE. CRITICAL SAFETY INSTRUCTIONS:
.
MOUNTING CORD REEL
1.
Unpack and inspect reel for damage. Turn by hand to check for smooth
operation. Check for completeness.
2.
Configure reel for top, side or bottom-wind (bottom-wind for constant
tension reels only) electrical cord dispensing by removing screws,
securing guide arm bracket. Determine new guide arm location and
remove corresponding screws. Position guide arm bracket to reel and
replace screws.
3.
Position reel on floor, wall, or ceiling. Secure into place, using four
(customer supplied) screws or bolts.
4.
Attach power cord from reel to
Voltage: 120
-277
V AC
compatible receptacle
.
WARNING:
Check product label for correct voltage! Failure to comply could
result in damage to the fixture which may not be covered by warranty.
CAUTION:
Unless the reel was specified differently when ordering, the maximum installation height is 16 feet. Do
not exceed this distance.
WARNING:
Ensure that the power supply voltage does not exceed maximum voltage rating of reel. Observe applicable
NEC. OSHA, and local electrical codes.
WARNING:
Pull electrical cord from reel by grasping the electrical cord itself, not the work device.
OPERATION
Reel handlamp and position light head in desired location using swivel hook. Grasp cord stop to begin reeling cord, not
hand
held spotlight
.
The LED lamp in this
spotlight i
s “instant-on” and will illuminate once power is supplied.
•
Do not exceed the voltage or ampere rating of the cable. Do not exceed the voltage or ampere rating of the reel.
Overheating, fire, damage to equipment or personal injury could result.
•
Do not allow cable to retract without restraining the retraction speed.
•
Operate the reel within the cable size and length and spring tensioning limits for which it was intended.
•
Two wraps of cable should remain on the reel at maximum extension to avoid excessive tension on the cable
entrance watertight.
•
The spring should not be wound to its last two turns at maximum payout to avoid over-stressing the spring, thus
reducing its life or damaging the reel.
•
Keep the reel and cable clean to avoid excessive wear and damage.
•
Arrange for maintenance service if damage is found on the cable or reel.
•
Cable should be fully retracted when not in service to maximize spring life.
