![background image](http://html1.mh-extra.com/html/federal-signal-corporation/valor-valr44/valor-valr44_installation-maintenance-and-service-manual_3957658020.webp)
20
Valor
®
Light Bar
Federal Signal
www.fedsig.com
Wiring the Valor in the Vehicle
Wiring the Valor in the Vehicle
Before proceeding, ensure that the light bar has been installed on the vehicle roof
in accordance with the instructions included with the mounting kit. Depending on
the type of vehicle and mounting system feature, there are two options available
for installing the light bar to the roof of the vehicle: hook-on mounting or permanent
mounting.
INSTALLATION PRECAUTIONS: The warning system and/or two-way radio
system may operate improperly if a two-way radio antenna is installed on or
within 18 inches of the light bar. Before permanently installing the light bar or
a two-way radio antenna, test the warning system and two-way radio system.
Some installations may require the relocation of the two-way radio antenna
to the trunk or fender. DO NOT drill holes in the light bar or install auxiliary
devices on the light bar, or the warning system may fail.
Planning the Electrical Installation
The light bar is completely wired at the factory and does not require any additional
internal wiring. All the conductors necessary for control of any and all basic and
optional functions are contained in the CAT5 cable. The basic light functions of the
Valor must be controlled by a installer-supplied control head.
To prevent damage to the light bar and vehicle and ensure that all equipment
operates properly, carefully plan where to mount and wire the light bar and controlling
equipment:
1.
Verify that the light bar and mounting hardware fit the vehicle.
2.
Determine where to mount the light bar on the vehicle.
LOCATING OPERATOR CONTROLS: The controls for the light system must be
located so that the VEHICLE and CONTROLS can be operated safely under all
driving conditions.
UNIT REQUIRES SHELTER FROM WEATHER—The Serial Interface Module is
NOT waterproof. It must be mounted in a location that is sheltered from rain,
snow, standing water, etc.
3.
Determine where to mount the controlling equipment:
• Trunk or remote location
• Console