Federal Signal Corporation SmartSystem SS2000C31, Инструкции по эксплуатации и настройке

Страница: 9 / 24

LEVEL 1 (Keyboard)
-7-
Always leave the
Slide Switch OFF
while
reconfiguring.
LEVEL 1 (Keyboard) is where op-
tions are chosen that affect the en-
tire keyboard. These options are
whether you want the siren keys to
act independently of the rest of the
keyboard, whether you want the de-
fault, factory settings, configuration,
or whether you want configuration
mode disabled after this configura-
tion session.
SAVE
Save displayed LEVEL 1 settings
and return to MAIN MENU, page 6.
Function Indicator
Sound
If key 12 is on, the control head will
beep about every ten seconds if a
function, besides the sirens, is active.
Directional Light 6
If key 13 is on, then the directional
light will operate in the 6-Lamp
mode.
If key 13 is off, then the directional
light will operate in the 8-Lamp
mode.
Sirens Independent
If key 14 is on, then the sirens will
act independently of the slide
switches. That is, in operation mode,
if a siren key is pressed, the siren
tone will be produced immediately.
If key 14 is off, the sirens, in opera-
tion mode, will require that one of
the slide switches be activated be-
fore the siren tone will be produced.
Which slide switch will turn on the
sirens is optional and will be dis-
cussed in Level 2 - Slide Switch -
Function, on page 10.
Default Configuration
If key 15 is on, then the keyboard is
configured according to the factory
default settings (see OPERATION,
page 1).
If key 15 is off, then the present con-
figuration does not match the factory
default settings.
To put the system back in factory
default configuration, turn key 15
on. Remember, this will erase all
previous configuration information.
Configuration Mode
Disable
If key 16 is turned on, you will not
be able to re-enter configuration
mode once you exit this session. To
re-enter configuration mode at a
later date, the “Push To Talk” but-
ton on the microphone for the siren
system must be on while the SAVE
key is pressed to enter configuration
mode as referred to on page 6. The
Push to Talk button must be held
until you re-enter level 1 and turn
off key 16. Once this is accomplished
you can release the Push to Talk
button on the microphone and pro-
ceed with reconfiguration as normal.
SmartSystem-LMS
SAVE
Directional
Light
9 10 11 12 13
14
15 16
4 5 6 7 8
20 19 17 18
Configuration
Mode
Disable
Function
Indicator
Sound
Sirens
Independent
Default
Configuration
290A4318-03
OFF 1 2 3