Fayat Dynapac F80W, Руководство по эксплуатации

Страница: 142 / 198

136 F80W
451117
3
2
1
18
17
451082A
3.6 Lubrication and maintenance operations
3.6.5 Cleaning the hopper, outlets and
conveyor
Before applying the anti-adherent solution remove gross dirt
from the conveyor, material outlets and the hopper of the ma-
chine.
Clean the driver’s stand always on the machine which is parked
on a flat and solid surface, with the machine engine and battery
disconnecter off.
Cleaning procedure:
• Make sure the material hopper (1) is empty.
• Apply the anti-adherent solution on the material hopper (1),
material outlets (2) and conveyor (3).
• Use a scraper to remove material residues from the material
hopper walls (1).
• Use a scraper to remove material residues from the material
outlets (2).
• Use a scraper to remove material residues from the convey-
or (3).
• Start the engine.
• Activate the function of conveyor start by shifting the op-
erating mode controller (17) to the lower position and the
controller (18) on the main dashboard to remove dirt from
the hopper area.
• After removing dirt from the hopper area disable the switch
(18) and the operating mode switch (17) functions.
• Turn off the engine and disconnect the battery disconnect-
er.
• Apply the anti-adherent solution on the material hopper (1),
material outlets (2) and conveyor (3).
Caution! There is a risk of injury during cleaning.
Remove dirt from the hopper area using a scraper only
with the engine and battery disconnecter off.
Use the prescribed protective equipment during
cleaning.
Use the prescribed anti-adherent solution according to
Chapter 3.2.4.
It is prohibited to use diesel oil instead of an anti-adher-
ent solution.