Part No. SCAZ042891 1.3.4
32
E&OE
Operating Instructions Scarab M6
Suction nozzle clearances
Inspect the suction nozzle flaps to verify that they are in
good condition and do not show excessive wear. Adjust as
necessary to achieve the correct flap to ground clearances.
The factory settings are:
• Inboard Side Flap = 15 mm
• Front Flap = 20 mm
• Rear Flap = 15 mm
These clearances are based on the factory set-up. For
some operating conditions, it might be found that,
alternative clearances are preferred.
Side brushes & skirts
Do not attempt to alter the brush settings while the
brush is rotating.
An effective brush set-up ensures good sweeping
performance. The following settings produce excellent results
in most conditions. Experience will determine if other settings
are better suited to specific conditions.
1. Vehicle stopped, handbrake ON, sweep mode ON,
activate the desired brush(es) in their working positions.
2. Switch OFF ignition and remove the key.
Before proceeding ensure people and objects are clear of
the brush area.
3. Locate the appropriate valve(s) in the pneumatic cabinet
and activate the manual override to allow the brush(es)
to extend.
4. Adjust the top link (
1
) and/or the motor plate (
2
) until the
brush is at the correct contact with the road surface.
Re-tighten any items slackened during adjustment.
5. Re-start vehicle, stow all sweeping equipment activated
for adjustment.
FRONT FLAP
REAR FLAP
INBOARD SIDE FLAP
Adjust for
Parallel Running
TOWPOINT
SKID PLATE
315/320mm
M
O
TO
R
C
EN
T
R
E
MOTOR CENTRE
BRUSH PATTERN
FIXING NUTS
1
2
MANUAL OVERRIDE
!
C
Содержание SCARAB M6
Страница 26: ...Part No SCAZ042891 1 3 4 26 E OE Operating Instructions Scarab M6 AREA MOST LIKELY TO SUFFER A BLOCKAGE ...
Страница 43: ...Part No SCAZ042891 1 3 4 43 E OE Operating Instructions Scarab M6 Operator s notes ...
Страница 44: ...Part No SCAZ042891 1 3 4 44 E OE Operating Instructions Scarab M6 Operator s notes ...
Страница 45: ...Scarab M6 Operating Instructions Part No SCAZ042891 1 3 4 47 E OE ...
