Fayat Group SCARAB M6, Техническое эксплуатационное руководство

Страница: 17 / 46

Part No. SCAZ042891 1.3.4 17 E&OE
Operating Instructions Scarab M6
Suction fan boost setting
When required a boost setting is available for the suction fan. This increases fan speed and is used when sweeping heavy material. To operate the
fan at the Boost setting, carry out the following procedure:
1. With the suction fan running press the BOOST switch . Refer to Page 12.
Sweeping
1. Switch on the hazard warning beacons.
2. Switch on the suction fan . The suction fan symbol on the LCD Monitor will change from WHITE to GREEN.
3. Select the desired configuration of brushes/suction boxes and water sprays (any combination of brushes and water can be selected) either
manually or by pressing the Favourite Settings switch to recall your preferred arrangement. Switch on work-lights as required.
4. Move the Multi-Function Switch (located on the auxiliary control panel) to the ‘Sweep Master Switch ON’ position to start and
deploy the pre-selected sweeping equipment.
To stop and stow the sweep gear, return the switch to OFF. The sweeping equipment will raise to the stowed position and all
water spray jets will stop (this will also occur automatically as soon as REVERSE is engaged, reverting to the original configuration
as soon as REVERSE is disengaged).
5. Operate the multi-function switch to swing the side brushes OUT and the Nozzle Tilt switches (auxiliary control panel) as
required to suit the sweeping conditions. The multi-function switch can also be used to control nozzle-tilt (Refer to page
12, for operating details).
While in the ‘Sweep Master Switch ON’ position, the multi-function switch will automatically return to the central position
from the side brush and nozzle control positions.
6. Select the forward ratio best suited to the prevailing sweeping conditions and commence sweeping.
If considered appropriate reduce/increase auxiliary engine speed to suit the prevailing sweeping conditions, by means of the engine
speed controls on the main panel. Engine speed can only be adjusted between its minimum effective speed for the situation and
the active preset default speed. Can not be adjusted in
SUCTION FAN BOOST MODE .
Be aware that too much reduction of engine speed can adversely affect suction performance.
Whatever the situation, remember that the rules of traffic and road safety must be observed.
OFF
ON
ON
SIDE BRUSH SIDE BRUSH
TILT