Chapter 5— Optimizing Printer Performance
56
EasyCoder 4420 and 4440 Bar Code Label Printer User’s Manual
Adjusting the Label Mark Sensor
The label mark sensor detects the black mark on the back of continuous
media stock. The printer uses the output to determine the start of print.
The label mark sensor is behind the platen roller and near the inboard
edge of the printer. You can position the label mark sensor no more than
6.35 cm (2.5 in) from the inboard edge of the printer.
To adjust the label mark sensor
1
Remove the media cover and locate the label mark sensor.
2
Use your index finger to slide the label mark sensor to the correct
position for the media. You can position the label mark sensor anywhere
from the inboard edge of the printer to the center of the paper path.
44XXU052.eps
Label mark
sensor
Locate the label mark sensor
behind the platen roller near
the inboard edge of the printer.
Use your finger to adjust
the label mark sensor.
Platen
roller
Inboard edge
of printer.
The platen roller
is not shown
for clarity only.
3
Print a few labels to make sure that the label mark sensor is detecting
the black mark on the media.
4
Replace the media cover.