6
SETUP INSTRUCTIONS -
MONEY SYSTEMS
1. The F820 machine supports
ONLY
MDB (Multi-drop Bus) 24V Money systems.
2. The F820 machine is compatible with any MDB compliant coin mechanism and bill acceptor.
3.
A dollar coin block plate is provided to prevent dollar coins from being inserted. The
plate can be removed to accept dollar coins.
4. The F820 comes pre-wired for a DEX port located on the inside of the control panel. To collect
DEX data, insert the DEX plug into the phono jack and pull out the vend / service interlock switch
located at the bottom right of the cabinet.
MONEY SYSTEM INSTALLATION
Multi-Drop Bus (MDB) Interface
1. With machine powered OFF.
2. Open the control panel-cover using the release button located on the right side of the control
panel.
3. Mount the coin mechanism using the three coin mech. mounting screws.
4. Mount the bill acceptor using the four mounting screws located on the control panel cover
(top or bottom slot depending on type of acceptor used; for card readers, use top slot- MDB
only)
5. Make all the connections.
6. Power up machine, following
INITIAL POWER UP
procedure below
!
INITIAL POWER UP
Plug the
machine
into the power source. To avoid the risk of injury, making sure that all body parts
are clear of the cabinet before turning on the main power.
The robot should follow the initial power-up sequence:
1. Robot picker head moves UP.
2. Robot carriage moves towards the LEFT of the cabinet.
3. Robot carriage moves towards the FRONT of the cabinet (considered the HOME position).
If the robot does not move or follow the “Homing Sequence”:
1. There may be setup errors or shipping damage. Review all the previous sections and check for
errors on the display. If the machine is out of order press the # key for diagnosis.
2. Check the transformer reset breaker and make sure the power switch is on (refer to control
panel diagram for location).
3. Perform a quick check to see if there are obstructions preventing the robot from moving freely
on all axes.
a. Power the machine off to disable “dynamic breaking” features that make it hard to
move the robot manually.
b. Manually move the robot to the left, right, front and back. Check for smooth travel.
Note any obstruction or gear binding.
4. Refer to the Troubleshooting Guide section.
BIN SETUP / PRODUCT LOADING
The
F820
utilizes a bin system to hold product. The bin system is made up of a number of bins
(various shapes and sizes), held together by a plastic bin matrix. The type and size of bin used
depends on the size and shape of the product being vended. Every
machine
comes pre-
configured with a specific bin layout or “Bin Plan-o-gram”.
GENERAL CONSIDERATIONS
1. To keep track of products in a bin configuration, we recommend that the plan-o-gram form be
filled out and attached to the inside of the machine. The product name, price and bin number can
also be written directly on each bin. In addition, the computer is programmed to leave one product
at the bottom of each bin allowing products to be matched by the service person for refilling.
Содержание F820
Страница 1: ...F820 Service and Parts Manual Ver FC031504...
