Fastbind Pureva XT, Руководство пользователя

Страница: 16 / 20

Fastbind PUREVa Xt UsER manUal | v 1.0 | © maping Co 2014
16
DRAFT
turn table Handle
• when in the neutral position, the nipping
plate is open and the turn table is in the down
position.
• by turning the handle up, the turn table rotates
to up or ”gluing” position.
• by turning the handle down, the nip plate moves
to press the book spine.
o warning!
▪
always use the handle to rotate the turn
table or it may, suddenly drop back
to the down position. risk of personal
injury and machine failure.
10. funcTIon descrIPTIon
10. FunctIon dEScrIPtIon
nIppIng tools
• the machine is delivered with two pairs of
nipping tools for spine pressing. a pair includes
a moving tool (in front) and a back support.
• soft cover tools are marked with letter s and
hard cover tools with letter H.
• Install the back support to the rear part of the
positioning deck against the back limiter. the
back support is held tight with magnets.
• the moving tool is placed to the front of the
positioning deck on top of the nipping cams.
claMp
• the clamp handle is spring loaded. pull the
clamp up and release the handle to lock it to
the up -position.
• the clamp stays in the up position when the
locking pin rests in the slot on the support rod.
• press the handle down against the u-shaped
groove to move the clamp. slide the clamp so
that it touches the book block.
• turn the handle all the way up to lock the
clamp.
• when putting a book cover in the binder, lift
the table slightly up with the cclamp handle and
slide the cover in from above.
• when closing the clamp, press the support rod
down to hold the table in position when locking.
Figure 10-x X
Figure 10-x X
Figure 10-x X