36
│ 53
Manual
TRITON HEAVY 660 PS
SETTING THE WORKING DEPTH OF THE FRONT DISC SECTION
▪
The working depth of the disc section depends on the set depth of the chisels.
▪
The setting range for the front disc section is 300 mm so that it is possible to cover the range of the
working depth of the discs from 60 to 180 mm for all the working depths of the chisel section.
▪
The working depth of the discs must never exceed
180 mm
.
▪
The working depth is set by clips on the piston-rods for the disc depth (
GREEN CIRCUIT
).
▪
Removing the small washer (
blue, 13 mm
) increases the working depth
by about 20 mm.
▪
Removing the large washer (
grey, 25 mm
) increases the working depth
by about 40 mm.
▪
To perform the settings, fully eject the piston-rods (
GREEN CIRCUIT
).
▪
To work, draw the piston-rods into the clip end stop and set the pressure on the pressure gauge at
180
bar
.
▪
When changing the working depth of the chisels, always check the working depth of the disc section.
▪
Proceed from a smaller working depth to the higher working depth during setting.
