Manual
EXCELENT Premium 6; 8
27
│
52
4.3.2
Controlling Rail Line Markers
If the function of rail line markers is on (provided that the machine is equipped with them), the marker turns on
automatically at the moment of the formation of rail lines, see Picture 35. Marking is recessed when the machine
is lowered into the swathe.
Example; functions lifting/lowering of the machine, right marker and rail line marker are on. In Picture 34 the
function of markers is on but the indicator shows that the rail line is not formed and therefore the marking is not
functional. The indicator in Picture 35 shows the formation of rail lines and therefore the marking is functional
and operating.
Picture 34 – Example of the marking function
Picture 35 – Formation of rail lines
4.4.
OPERATION OF THE MAIN DISPLAY
All deviations from normal condition are diagnosed by flashing of the relevant icon in
red colour on the display of the controlling unit and by acoustic signal!!!
4.4.1
Travel Sped of the Machine
This value is indicated by the radar on the sowing machine and it is for information only. The value
should be the same as of the tractor; it may be different when the tractor wheels slip. The difference in
speed is not indicated.
4.4.2
Fan speed
Shows the current fan speed. When the speed drops down below the set value (see Chapter 4.5.1./p.29),
the fan icon starts flashing red and the acoustic signal sounds. When the machine starts without the fan on,
the defect is also indicated.
Emergency setting of the sensor:
if there is a failure of the rev sensor and we do not have a spare one,
the system will display an error in revs during the drive. The acoustic signal may be turned off in this
status by setting the minimal revs to the “0” value (see Chapter 4.5.1/p.29)
4.4.3
Hectare Gauge
This function has two modes. There is a daily hectare gauge that can be set to zero by pressing the button
for zero setting of the daily hectare gauge, Picture 30/p.24 and then by pressing button “C”. The total
hectare gauge shows the summary area which the machine has sown since its operation. This value cannot
be deleted. Both gauges only measure sowing, i.e. they do not MEASURE during plough turning ends,
crossings and other manipulations with lifted machine!!
4.4.4
Rail Line
The individual runs of the machine are counted during the operation of the machine. On the basis of the
set programme, rail lines are created after a certain number of runs (cycles). The runs are calculated on the
basis of the sensor of the lift of the machine. It is possible to enter these runs any time and change them by
pressing the button for rail lines and then adding or decreasing.
When editing, a red line appears below the numbers to show what is edited. The rail line can be also
blocked when driving around obstructions, when sowing at the edges of the fields etc. Blocking is
performed by pressing the rail line blockage button. The blockage can be supported by an acoustic signal.
When working without rail lines for a longer period of time, the acoustic signal can be turned off
Indicator of the
rail line formation
