Farmet DUO, Руководство по эксплуатации

Страница: 27 / 48

OPERATING MANUAL
OILSEED SCREW PRESS FARMET DUO
Page 27 of 48
7. ADJUSTING OPERATING MECHANISMS

When adjusting the operating mechanisms of the Equipment, the Operator must follow
the recommended values specified in the Operating Manual. Always observe the
principles of safe operation of the Equipment and instructions provided in
Chapter 5.1
and Chapter A .

The Operator may only adjust the operating mechanisms when the Equipment is in
standstill, i.e. the Equipment is not operating. When adjusting the operating
mechanisms, always turn the Equipment off and place a sign on the control cabinet
stating “DO NOT TURN ON, THE EQUIPMENT IS BEING REPAIRED!”
7.1 ADJUSTING THE OPERATING PARTS OF THE EQUIPMENT
Figure 5 - Cross Section of the Operating Part of the Equipment
You can only adjust the equipment when the press has been disconnected from the power
supply!!!
The adjustment of the press is very easy and it lies in the correct setting of the front (die)
against the screw.
It is executed in the following way:

Clean the pressing mechanism.

Screw the nozzle holder in until its front is leaning against the screw.

Release the nozzle holder by 1.5 revolutions and secure it with a nut.

Screw a 10 mm nozzle into the front (new press).

When the operation of the pressing mechanism has been stabilized, you can replace the
10 mm nozzle with 8 mm and later with 6 mm. The best yield is achieved with the 6
mm nozzle.

The 4 mm nozzle may be used for oilseeds with the minimum fat content of 20 %.