Farmet DUO, Руководство по эксплуатации

Страница: 33 / 48

OPERATING MANUAL
OILSEED SCREW PRESS FARMET DUO
Page 33 of 48
9.4.1 Lubrication Plan
Table 4 - Lubrification plan
LUBRICATION SPOT INTERVAL LUBRICANT
Press Gearbox First 300 hours, then at least
once every 12 months CLP 220 with viscosity of
VG 220; quantity: 2.2 l.
9.4.2 Gearbox Maintenance and Operation
The maintenance of the gearbox is simple. If the operating control registers any signals of a
potential failure, any further operation is forbidden.
Most important points of the failure signals:

Checking temperature in the place of the bearings fitting

Checking the oil content level

Checking the noise level of the gearbox

Checking tightness

Checking the cleanliness of ventilation
If any irregularities are found during the operation, such as noise, increased temperature of
the bearings or increased temperature of the oil, switch off the equipment. If the gearbox is in
the guarantee period, immediately inform the service centre. If it is not possible to determine
the cause of the defect or the defect cannot be repaired, we recommend contacting the service
centre.
Use CLP 220 oil with viscosity of VG 220, quantity: 2.2 L.
The oil can only be discharged when the gearbox is in complete standstill. We
recommended discharging the oil warm. The first oil exchange is after 300 hours of
operation, then in the maximum interval of 1 year.
When exchanging the oil, the gearbox is filled with the same type of oil as used previously.
Mixing various types of oils or oils by various producers is not recommend; consult the oil
producer.
Never mix synthetic oils with mineral oils . When exchanging oil, changing the type of
oil or transferring from mineral oils to synthetic oils, the gearbox must be properly rinsed with
the new oil in advance. Use the same oil for rinsing the gearbox that will be used in the
gearbox after the exchange.
Procedure for oil exchange

Secure the driving unit to prevent accidental activation!

Unscrew the filler plug on the gearbox.