Farmet DUO, Руководство по эксплуатации

Страница: 25 / 48

OPERATING MANUAL
OILSEED SCREW PRESS FARMET DUO
Page 25 of 48
6. OPERATION OF THE EQUIPMENT
6.1 INSPECTION OF THE OPERATING VALUES AND PARAMETERS
The Equipment may work continuously with regular inspections provided that a regular
feed of material has been ensured.
Many problems and defects may be prevented by regular inspection rounds, during
which you should check:

Noise, vibrations
– increase in noise, banging, creaking or vibrations may signal wear
or malfunction – of bearings and other components. If such a noise is present, try to
identify its location and inform your service technician, or the Producer’s service.

Temperature
– The press warms up significantly during pressing (by friction of the
pressing bodies) but its operating temperature stabilizes (it depends on the ambient
temperature and the temperature and humidity of the pressed material). If there is an
increase in temperature, inform your service technician or the service centre. If the
higher temperature is caused by a high temperature in the press shop, provide better
ventilation or decrease the pressing capacity (decrease revolutions).
6.2 BREAKDOWN
In case of an unnaturally loud noise coming from the Equipment (banging,
creaking, blows) or in case of smoke or any other dangerous situation, immediately
stop the material feed. If there is a risk of injury of the employees or damage to the
property or the Equipment, immediately stop the Equipment, contact the service
centre.
The Equipment may only be activated again after the cause of the breakdown
has been identified and removed.
Please, contact the service centre in case of any uncertainties or unknown failures. The
contact information is provided on the title page of the Operating Manual.
6.3 SUDDEN STOP OF THE PRESS
If during the press operation suddenly stop due to overload, do the following:

Stop the flow of seeds in the press

Let press to cool for several minutes

Unscrew the nozzle and start the press shortly

In the event that the press does not rotate, remove the nozzle holder and press shortly
start