This manual is designed to make it as easy as possible for you
to assemble, install, operate, and maintain your ceiling fan
Unpacking Instructions
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
steps have been completed and will be helpful in
¿
nding your place should you be interrupted.
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are missing,
contact your local retailer.
Tools Needed for Assembly
Materials
Wire Size A.W.G.
Installed Wire Length
14
12
Up to 50 ft.
50 - 100 ft.
NOTE: If you are uncertain of part description, refer to
exploded view illustration. (Figure 1, page 16)
3
1.
Check to see that you have received the following
parts:
2QH3KLOOLSVKHDGVFUHZGULYHU
2QHVWHSODGGHU
2QHóÝ
blade screwdriver
2QHZLUHVWULSSHU
Three wire connectors
(supplied)
ʆ
WARNING
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation could
result in personal injury or property damage. Contact
your retail store for missing or damaged parts.
ʆ
WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 9). If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
Fan Motor Assembly
Light Fitter Assembly
6RFNHW3ODWH$VVHPEO\
Trim Ring Assembly
Hanger Bracket Assembly
Downrod/Hanger Ball Assembly
Ceiling Canopy
Canopy Screw Cover Assembly
Motor Coupling Cover Assembly
Blade Holder Set
Blade Set
Glass
Light Bulb
Fan Motor
Assembly
Downrod/
Hanger Ball Assembly
Ceiling Canopy
Hanger Bracket
Assembly
Motor Coupling Cover
Assembly
Blade Set
Hardware Bag
Glass
Trim Ring Assembly
Canopy Screw Cover
Assembly
Blade Holder Set
Light fitter Assembly
Socket Plate Assembly
Light Bulb
+DUGZDUHEDJV
– Eleven 1/4-20 x14 mm
3KLOOLSVKHDGVFUHZVZLWK
lock washers
(blade holder to fan motor hub)
(blade to blade holder)
±3KLOOLSVVFUHZGULYHUÝ
– Four wire connectors
– Balance Kit
±3XOO&KDLQ.LW/LJKW
– Chain Coupler
– Chain Fob
– Sixteen 3/16
Ý
-24 x 10 mm
Serrated head screws with
flat washer
±7ZR[Ý-XQFWLRQER[
– Two Flat Washer Ø10 x Ø5 x 0.8
mm, stainless steel
screws, stainless steel
