6
How to Assemble Your Ceiling Fan
1
.
Remove the hanger ball
portion
from the downrod/
hanger ball assembly by loosening the set screw in the
hanger ball until the ball falls freely down the downrod.
Remove the pin from the downrod, then remove the
hanger ball. Retain the pin and hanger ball for reinstal-
lation in Step 7. (Figure 1)
Downrod
Downrod
Set Screws (2)
Black, White and
Blue Leads
Set Screw
Pin
Hanger Ball
Figure 1
Figure 2
Figure 3
4.
Loosen the two set screws in the downrod support
of the motor assembly. Route the black, white and blue
wires through the downrod. (Figure 4)
5.
Slide downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod. Se-
cure clevis pin with hairpin clip. Tighten the two set
screws with nuts in the downrod support. (Figure 5)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in
the fan falling.
2.
Remove the hairpin clip and clevis pin from the
bottom of downrod. Retain the pin and clip for
reinstallation in Step 5. (Figure 2)
Hairpin
Clip
Clevis Pin
Downrod
Hairpin Clip
Clevis Pin
Rubber motor
stops
3.
Remove the five rubber motor stops from the motor
assembly and discard the stops. (Figure 3)
Set Screws and
Locking Nuts (2)
Figure 4
Figure 5
