Lumina 71
Alarm
48
15.5
Alarm overview
Report
Type
Description
Power out
L
Mains voltage has been down.
Alarm switched off
S
The alarm has been switched off.
Alarm test
L
The alarm has been tested.
'TOO MANY ALARMS'
L
Too many alarms active simultaneously.
Please contact your installer if the system alarms below occur.
Report
Type
Description
System alarms
L
Alarm in the actual control unit, e.g. memory or back-up alarm. +
all Error reports.
'BACKUP ALARM'
L
Incorrect settings.
Communication error
L
Communication error with FNet or more masters in loop.
Communication error with I/O module.
'IO-Net ADR: "Address"
L
Communication problems with IO-net module (weigher, relay,
inputs) with report of IO-net module address.
'TOO LITTLE BLEND'
L
Too little has been dosed out.
'TOO MUCH BLEND'
L
Too much has been dosed out.
"Name ingrd." MIN. STOCK.
S
An ingredient stock has fallen below its minimum limit.
"Name ingrd" TOO LITTLE'
L
During dosing in the weight in the weigher does not increase
sufficiently so the weighing process cannot be continued.
"Name ingredient" TOO MUCH'
L
During dosing in too much ingredient.
"Name ingrd REPLACE'
S
Replace ingredient by substitute ingredient.
'SILO NOT SWITCHING'
S
The silo does not open when dosing in.
'WEIGHER MAX TARE'
L
The maximum tare of the weigher has been exceeded.
'WEIGHER MAXIMUM'
L
The maximum weigher content has been exceeded.
“FP name” BLEND'
S
Blend not 100% at day change.
“FP name” BLEND DP'
L
Blend not 100 % at dosing in.
“FP name” LIMITED'
S
Calculated amount doesn’t fit into trough.
FP name” NO SENSOR'
S
FP with sensor set but no sensor assigned.
NO “name ingrd” “FP name”
-/S/L
No ingredient of type “name ingrd” in blend for feed place “FP
name” .Amount too small, has been ignored.
'Curve name” blend'
L
Sum of ingredients in curve not 100%
'CIRCUIT COMPL. 'FP'
L
Error when assigning feed place order.
'OVERLAP FEEDING CYCLE'
S/L
At feed clock “silent/loud/emergency stop”
'OVERLAP “Name clock”
S/L
At clock(s) after power out.
' Emergency stop '
S
After manual emergency stop.
'BLENDER NOT SWITCHING'
L
The blender feedback signal indicates that the blender is not
running although it has been sent a drive command.