From phone:
321 #
Return to default acknowledgment:
From keypad:
From phone:
# 321 #
Note: If a speech message is used; press any key to stop the message.
Acknowledge on end – 323
When the ECII™ Flex calls out an alarm duplex conversation is automatically connected. But if
there is no answer and no tone (0-9) received the ECII™ Flex will disconnect and call next
alarm receiver. If Alarm receiver 1 is busy, does not answer or an answering machine answers
the call the ECII™ Flex will call Alarm Receiver 2 and so on. Each time any of the tones (0-9)
is pressed by the receiver the disconnect time-out is reset to 180 seconds. Only duplex mode
is available.
In order to acknowledge that the call has been received by an authorized person the receiver
must either press a tone during the conversation (0-9) or use the
button to disconnect the
alarm call. The
can be changed to any tone for disconnecting the call, use this if there are
other brands of emergency phones that require a different disconnect command.
The function is activated with:
From keypad:
From phone:
323 #
Return to default acknowledgment:
From keypad:
From phone:
# 323 #
Changing the disconnect command tone is made by:
From keypad:
<0-9,
, # >
From phone:
323
< 0-9,
, # > #
Note: If a speech message is used; press any key to stop the message.
Detection of busy alarm receiver
Detection of busy tone is default activated. The ECII™ Flex will detect busy tone and pause
between 100 – 800 ms. Should the tone and pause length be different then the default setting
this can be adjusted by programming.
From keypad:
<XXXX>
<YYYY>
where XXXX is tone and YYYY is pause. Steps in milliseconds 800-2500.
From phone:
710
< XXXX >
< YYYY > #
where XXXX is tone and YYYY is pause. Steps in milliseconds 800-2500.
Activating the function and returning to default settings is made with:
From keypad:
From phone:
710 #
162187 Manual FältCom ECII™ Flex
Page 26 of 40