Fagor CNC 8065, Конфигурация оборудования

Страница: 83 / 110

Hardware config urat ion
CNC 8065
7.
(R
EF
: 1404)
·83·
VERTI
C
A
L
-KEYB M
O
DULE.
VERTI
CAL KEYBOARD
W
IT
H
OR
W
ITHOUT M
O
USE.
7.2 Dimensions and characteristics of the enclosure.
The enclosure must meet the following requirements.
• Respect the minimum distances recommended between the enclosure walls and the
hardware to allow air flow. This space makes it also possible to bend the cables for the
hardware connection with the recommended bending radius.
• Keep the enclosure clean. If the enclosure has ventilation holes, anti-dust filters should
be installed in all of them.
Minimum gaps recommended between the enclosure walls and
the hardware.
Securing the module.
The module must be installed in a proper enclosure that may be located on the machine or
on an external support. To insert the unit into the enclosure, it must have a big enough hole
to allow to insert it easily, without obstacles and without forcing the unit.
The module is secured from the inside of the enclosure; therefore, there is no need to drill
any holes on the front. Once the unit has been inserted into the enclosure, secure it from
the inside with the tension jacks. To properly secure it, use all the tension jacks on the back
of the unit. Apply a maximum tightening torque of 0.5 Nm.
mm inch
W
125 4,92
H 322 12,68
D
74 2,91
e 1,5 – 4 0,06 – 0,16
mm in ch
Da
133,8 5,27
Db 107,8 4,24
W
H
External contour of module.
Contorno exterior del módulo.
e
D
Da
Db