Fagor 8055 FL, Руководство по эксплуатации

Страница: 194 / 210

·194·
Operating manual
CNC 8055
CNC 8055i
6.
SAVING PROGRAMS
·TC· O
PTION
S
OFT
: V02.2
X
Modify a
part-program
6.7.4 Modify an existing operation
To modify an operation, proceed as follows:
1. Select, with the pointer, the block or cycle to be modified from the right column.
2. Press the [RECALL] key.
The CNC will show the editing page for that operation.
3. Modify all the desired data.
To save the modified operation, proceed as follows:
1. Press [P.PROG] to access the list of part-programs stored.
The CNC shows the pointer on the same operation. To select another position, use the [

][

]
keys. The new operation will be inserted after the selected operation.
2. Press the [ENTER] key.
To place the modified operation in its previous location, the CNC will show a message asking to either
replace the previous operation or keep it inserting the new one after it.
The following example modifies the "facing cycle" operation:
Current program Option "Replace" Option "Insert"
1.- Facing cycle 1.- Facing cycle 1.- Facing cycle
2.- Taper turning cycle 2 2.- Taper turning cycle 2 2.- Facing cycle
3.- Taper turning cycle 2
It is possible to select an existing operation, modify it and then insert it in another position and even
in another part-program.
i