Fagor 8055 EN, Руководство по программированию

Страница: 297 / 482

Programming manual
CNC 8055
CNC 8055i
PROBING
12.
·M· & ·EN· M
ODELS
S
OFT
: V02.2
X
·297·
PROBE 1. Too
l leng
th
cal
ibratin
g ca
nne
d cycl
e
Actions after finishing the cycle
Once the calibration cycle has ended
It updates global arithmetic parameter P298 and assigns the measured radius to the tool offset
selected in the tool offset table.
P298 "Measured radius" - "Previous radius (R+I)".
P299 "Measured length" - "Previous length (L+K)".
R Measured radius.
L Measured length.
I 0.
K 0.
Once the wear measuring cycle has ended
• When using tool live monitoring.
In this case, it compares the measured radius and length with the theoretical values in the table.
If the permitted maximum value is exceeds, it issues the message indicating that the tool has
been rejected and acts as follows.
• If tool life monitoring is not available or the measuring difference does not exceed the maximum
allowed.
In this case, it updates global arithmetic parameters P298 and P299 as well as the radius wear
and length wear value of the tool offset selected in the tool offset table.
P298 "Measured radius" - "Theoretical radius (R)".
P299 "Measured length" - "Theoretical length (L)".
R Theoretical radius. It maintains the previous value.
I "Measured radius" - "Theoretical radius (R)". New wear value.
L Theoretical length. It maintains the previous value.
K "Measured length" - "Theoretical length (L)". New wear value.
If the dimension of each cutting edge was requested (“N” parameter) the lengths are assigned
to global arithmetic parameters P271 and on; the radii are assigned to global arithmetic
parameters P251 and on.
C0 It interrupts the execution so the user can select another tool.
C1 The cycle replaces the tool with another one from the same family. It sets the "rejected
tool " indicator (status = R). It activates the general logic output PRTREJEC (M5564).