Fagor 8055 EN, Руководство по программированию

Страница: 313 / 482

Programming manual
CNC 8055
CNC 8055i
PROBING
12.
·M· & ·EN· M
ODELS
S
OFT
: V02.2
X
·313·
PROBE
6
. Ang
le me
asurin
g ca
nne
d cycl
e
12.8.1 Basic operation
1. Approach movement.
Movement of the probe in rapid (G00) from the point where the cycle is called to the first approach
point, situated at a distance (B) from the programmed vertex and at (2B) from the face to be
probed.
The approaching movement is made in two stages:
·1· Movement in the main work plane.
·2· Movement along the longitudinal axis.
2. Probing movement.
Movement of the probe along the abscissa axis at the indicated feedrate (F), until the probe signal
is received.
The maximum distance to be traveled in the probing movement is 3B; if, after travelling that
distance, the CNC does not receive the probe signal, it will display the corresponding error code
and stop the movement of the axes.
3. Withdrawal movement.
Rapid probe movement (G00) from the probing point to the first approach point.
4. Second approach movement.
Rapid probe move (G00) from the first approach point to the second. It is at a distance (B) from
the first one.
5. Second probing movement.
Movement of the probe along the abscissa axis at the indicated feedrate (F), until the probe signal
is received.
The maximum distance to be traveled in the probing movement is 4B; if, after travelling that
distance, the CNC does not receive the probe signal, it will display the corresponding error code
and stop the movement of the axes.
6. Withdrawal movement.
Movement of the probe in rapid (G00) from the point where it probed for the second time to the
point where the cycle was called.
The withdrawal movement is made in three stages:
·1· Movement along the ordinate axis to the second approach point.
·2· Movement along the longitudinal axis to the coordinate of the point (along this axis) from
where the cycle was called.
·3· Movement in the main work plane to the point where the cycle is called.