Fagor 8055 EN, Руководство по программированию

Страница: 77 / 482

Programming manual
CNC 8055
CNC 8055i
ISO CODE
PR
OGRAMMING
5.
·M· & ·EN· M
ODELS
S
OFT
: V02.2
X
·77·
To
ol numbe
r
(T)
an
d to
ol offse
t (D)
5.6 Tool number (T) and tool offset (D)
With the "T" function, it is possible to select the tool and with the "D" function it is possible to select
the offset associated with it. When defining both parameters, the programming order is T D. For
example: T6 D17
To access, check and define these tables, refer to the operating manual.
How to use the T and D functions
• The "T" and "D" functions may be programmed alone or together as shown in the following
example:
T5 D18 Selects tool 5 and assumes the dimensions of tool offset 18.
D22 Tool 5 stays selected and it assumes the dimensions of tool offset 22.
T3 Selects tool 3 and assumes the dimensions of the offset associated with that tool.
• When having a tool magazine where the same position is occupied by more than one tool, do
the following:
Use the "T" function to refer to the magazine position and the "D" function to the dimensions
of the tool located in that position.
Thus, for example, programming T5 D23 means selecting the turret position 5 and assuming
the geometry and dimensions of tool offset 23.
Tool length and radius compensation.
The CNC looks up the "tool offset table" and assumes the tool dimensions corresponding to the
active "D" offset.
Length compensation is applied at all times, whereas radius compensation must be selected by the
operator by means of functions G40, G41, G42.
Length compensation is applied at all times, whereas tool length compensation must be selected
by the operator by means of functions G43, G44.
If there is no tool selected or D0 is defined, neither tool length nor radius compensation is applied.
For further information, refer to chapter 8 "tool compensation" in this manual..
If the machine has a tool magazine, the CNC looks up the "Tool
magazine table" to know the position occupied by the selected
tool and the desired one.
If the "D" function has not be defined, it looks up the "Tool table"
to know the "D" offset associated with it.
It examines the "tool offset table" and assumes the tool
dimensions corresponding to the "D" offset.
Selects the tool
Magazine?
EZ
YES
YES
EZ
D?
The CNC takes the D
associated with the T in the
tool table
The CNC takes the
dimensions defined for the D
in the tool offset table