Faber Duet XL, Руководство по установке

Страница: 17 / 28

L
16 < < < <
11 Calculation of flue system
The possibilities for the lengths of flue pipes and the possible restrictors have been recorded
in a table (see chapter 12 ) This table works with a vertical and a horizontal length.

To define the vertical length all lengths of flue pipes in a vertical direction should
be added up.
-
The roof terminal always counts as 1 metre.

To define the horizontal length all lengths of flue pipes in a horizontal direction
should be added up.
-
every 90° bend in the horizontal part counts as 2 metres.
-
every 45° bend in the horizontal part counts as 1 metre.
-
Turns from vertical to horizontal or vice versa are not reckoned in the
calculation.
-
The wall terminal always counts as 1 metre.
If there is transit under 45° then the real vertical and horizontal lengths should be
calculated.
11.1 Points of particular interest:

In case of a wall terminal, the entire flue system including the wall terminal should
be constructed of 200/130 flue pipes.

In case of a roof terminal, the entire flue system should be constructed of 200/130
flue pipes , apart from the roof terminal, which should be constructed of 150/100
and should be connected by means of a reducer.

The maximum chimney length is 12 metres.

You can never start with a 90° or 45° bend from the appliance.

You should always start with 1 metre vertical if the horizontal transit is more than 1
metre.

You should never start with a cut-down pipe from the appliance.