Faber Duet XL, Руководство по установке

Страница: 9 / 28

L
8 < < < <
3 Installation requirements
3.1 The fire

The appliance must be built into an existing or a newly to be constructed false
chimney breast.

In appliances with flexible gas pipes, the gas control valve is mounted to the right
side of the fire for safe transport . Unscrew it and mount it at a distance of max. 30
cm behind the access door.

The receiver which has been attached in a transport holder (see fig.1.6 A) to the
side of control valve bracket, can now be slid onto the top of the control valve
bracket. The transport holder can be removed now.
3.2 False Chimney breast

The false chimney breast must be constructed of an non-combustible material.

Always ventilate the space above the appliance by means of the grills or a
comparable alternative with a minimum air supply of 200 cm².

For the finish, use special stucco (min. 100°C resistant) or glass fibre wallpaper to
prevent discoloration or cracks etc. Recommended drying time: for plaster is a
minimum of 24 hours per mm of coat applied.

The false chimney breast and its construction may not rest on the appliance
3.3 Requirements flue system and outlets

You should always make use of the materials prescribed by Faber International Ltd.
Only by using these materials can Faber International Ltd. guarantee a proper
functioning.

The outside of the concentric flue material can reach a temperature of
Approx 150°C. Make sure of proper isulation and protection in case of transit
through combustible wall or ceiling constructions. And observe sufficient distance.

Make sure that the concentric flue materials are bracketed every 2 metres when
they have an extended length, so that the weight of the flue material is not resting
on the appliance itself.

You may never start with a cut-down concentric pipe directly on to the appliance.